HTML syntax highlighting can be done easier than other languages because it follows a set pattern. You have tags, attributes, comments, and text. That's about it...So to make highlighting faster, I created a routine that works just for HTML. It's faster because it follows the set pattern for HTML instead of just finding keywords and highlighting those.
It works by first going and putting in the correct RTF color table switches and then storing all text up to an HTML tag (thus making it faster if you have more text b/c it skips everything in between). Then it highlights an individual tag at a time. It goes through and evaluates each tag and its constituients. It's pretty basic...anything to the left of an equal sign in the tag is going to be an attribute name (this color is the same as the tag color...I'll work on creating separate colors for this), and anything to the right will be the attribute value (colored in blue in the example). It will color values even if they're not enclosed in quotes. When you go to the next space, then we know we're at another attribute name EXCEPT in cases when we're in a quote. I had to add some code to make sure it didn't evaluate the next word after a space as an attribute name instead of as part of the quote. But that's all taken care of, so don't fret! (c: It will color comments as well.
Don't try using TagBold, TagItalics, etc. b/c in some configurations it will cause it to freeze and I don't know why yet. I will work on that. But it does work fine w/ any color configuration. You can use common dialogs to allow the user to select a color and it will work fine w/ those. It automattically interprets the colors and applies them to the RTF.
If you use the supplied owner created RichText box, you need to download the SSubTimer.DLL - great subclassing control/activex dll from vbAccelerator. The supplied project uses the standard RichTextBox control that comes with VB - if you want to change the DLL to use the supplied RTF control, you'll need to change the code slightly - see below.
It's rather simple, actually...I have it set up w/ an RTB made through code, but you can easily switch it to a normal RTB by changing the "Public RichTxtBox As HSRichEdit" to "Public RichTxtBox As RichTextBox". After that, to highlight, just use two lines of code:
set syntaxHighlight1.RichTxtBox = RichTextBox1 syntaxHighlight1.Highlight
To get it to color properly while typing, use the following code:
Private Sub RichTextBox1_KeyPress(KeyAscii As Integer) KeyAscii = syntaxHighlight1.KeyPressEvent(KeyAscii) End Sub
That's all it takes to set it up! Good luck! (c;